This evening, I used my fuse support again and sawed off the last piece of tube I needed to remove: the RH side diagonal (#1). Unlike the LH one, this member has not been repaired and was therefore much easier to remove since there was no ugly, distorted splice welded to it. I took a picture similar to the LH one so that you can see the difference...
Before my welder comes and pick up the fuse to bring it to his shop, last step is to remove the paint around the areas that will need welding. I intent to use a combination of heat and steel brush to achieve that. It's good to be slowly reaching the end of the tear down process. Not there yet, but close!
No comments:
Post a Comment